10-12-2016 11:10 AM
Hi, i need configure VPN tunnel between ASA and VMware vShield Edge. The configuration is fine, between to sides the tunnel is up, but the servers in both side don't have comunication. So, my question is.. What are the requieriment for servers can comunicate?
These are the configuration:
- I configure static route in ASA for can make connection with remote LAN (internal LAN)
# route outside IP_REMOTE_LAN_INTERNAL IP_REMOTE_PUBLIC_IP
- I configure ACL for crypto map where permit local internal lan traffic to remote internal lan traffic
# access-list name extended permit ip LOCAL_LAN REMOTE_LAN
- The internal remote and local LAN, don't overlies IP network address.
Thanks in advanced, regards!
Solved! Go to Solution.
10-13-2016 04:13 AM
Hi,
The problem was, i forget rule bypass NAT . So, this rule is fixed the connections between the servers in both sides.
nat (inside) 0 access-list ACL_NAME
Regards!
10-13-2016 04:13 AM
Hi,
The problem was, i forget rule bypass NAT . So, this rule is fixed the connections between the servers in both sides.
nat (inside) 0 access-list ACL_NAME
Regards!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide