VPN3000 and RIP v2 authentication

[serguei.bezverkhi]

Hi,

I have VPN 3000 box 3.6.7. I need to enable RIP v2 on outside interface. My problem is that I cannot find where I should specify that RIP v2 will use MD5 authentication and where I should specify RIP v2 authentication key. I look through the manual and could not find any references. It is hard to imagin that Cisco put RIP v2 on VPN 3000 but forgot to put authentication mechanism for it.

Appreciate a lot if somebody let me know whether it is possible or not.

Thank you

[murabi]

I don't think this is supported on the VPN 3000. As you should know already click the following URL to know the only two options possible,

http://www.cisco.com/univercd/cc/td/doc/product/vpn/vpn3000/4_0/config/interfac.htm#1019999