Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a requirement to limit number of multicast flows passing through a WAN link. Example: there are 10 multicast sources at one location but not more that 4 can be joined and active at one time. I have a bandwith reservation for 4 x 32kbps, ...
Hi,I have the following configuration. VPN3000 box, public interface runs OSPF, private interface runs RIP. I was looking for a way to control redistribution between OSPF and RIP.I particular I would like to know if it possible to disable redistribu...
Hi,I have VPN 3000 box 3.6.7. I need to enable RIP v2 on outside interface. My problem is that I cannot find where I should specify that RIP v2 will use MD5 authentication and where I should specify RIP v2 authentication key. I look through the manua...
Hi,It looks like in v4.0 of the sensor there is no any settings for PostOffice as it was with v3.0. Does it mean that Cisco is moving from old NetRanger concept, or PostOffice protocol will be added later in v4.0?Thank you
Hello,I would greatly appreciate if somebody could confirm two things:1. Whether PIX supports assigning IP addreesses to VPN clients from IP POOLs defined on Cisco Secure ACS 3.1 server?2. If I define several IP LOCAL POOLs on the PIX and assign them...
Hi,The problem is with automatic redistributing OSPF to RIP and not RIP to OSPF and I have this options disabled. I would like to advertise RRI to internal portion which is RIP. It would ebe nice to have a "similar" check box for RIP too.Thank youSer...
Hi,Thank you for such a prompt reply.The error that I have Says that my user does not have dial-in permission enabled. I have check and re-checked the user has this permission.What is happening, I have the same user defined on ACS server (Local SAM)a...
