Dear Cisco Community,
I hope this message finds you well.
I am currently working on configuring Wake on LAN on a Firepower 1000 series device and could use some guidance on the required steps, including NAT configuration. Here are the details of my network setup:
I have created a broadcast object for Wake on LAN with the following settings:
- Mask: 255.255.255.255
- Broadcast Address: 192.168.72.255
- Internal Network: 192.168.72.0/24
I have an "outside" network with the following details:
- IP Range: 192.168.70.0/24
I've established a VPN connection from outside to an Azure server with the following IP range:
- Azure Server: 10.0.0.0/16
Now, I'm looking to configure (NAT) and open a specific Wake on LAN port to enable communication from my internal network to the Azure server. The requirements are as follows:
- Configure NAT to allow traffic from the internal network (192.168.72.0/24) to the Azure server (10.0.1.10).
- Open U D P port 9/7 for Wake on LAN.
- Access Control
I would appreciate any guidance or configurations needed on the Firepower 1000 series device to make this Wake on LAN setup work, including the necessary NAT rules and port configuration.
