WARNING: Strongly recommend to configure a virtual MAC address for each span-cluster port-channel interface or all subinterfaces of it in order to achieve best stability of span-cluster port-channel during unit join/leave.

[Ibrahim Jamil]

Hello Guys

pls advise on the below , how can i configure

ASA-DC(cfg-cluster)# enable
WARNING: Strongly recommend to configure a virtual MAC address for each span-cluster port-channel interface or all subinterfaces of it in order to achieve best stability of span-cluster port-channel during unit join/leave.
ASA-DC(cfg-cluster)#

thanks all

[Flavio Miranda]

Hello @Ibrahim Jamil

failover mac address phy_if active_mac standby_mac

-If I helped you somehow, please, rate it as useful.-

[Ibrahim Jamil]

Hello Flavio

I m using G0/0 between  ASA in cluster mode , the MAC for :

ASA1 g0/0 is 11:22:33:44:55:66

ASA2 G0/0 IS 22:55:77:AA:DD:CC

Cluster-Interface : 1.1.1.1 ASA1 and 1.1.1.2 ASA2

as per the above info how to do the below commad

ailover mac address phy_if active_mac standby_mac

thanks

[Flavio Miranda · Accepted solution]

Hi @Ibrahim Jamil

Let´s say ASA 1 is Active:

failover mac address 11:22:33:44:55:66  22:55:77:AA:DD:CC

-If I helped you somehow, please, rate it as useful.-

[Ibrahim Jamil]

thanks flavio