When both interfaces are on same security

[Hemant Sajwan]

On FWSM, when two interfaces are at same security level and you see Reset-O or Reset-I in the syslogs, how to determine who sent the reset? There's "sh np 3 pif vlan ..." command for it.

However, my question, what is the equivalent command for it on ASA?

[Rudy Sanjoko]

show connection detail and show log should give you the information.

http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a0080bcad00.shtml

HTH

[Hemant Sajwan]

Thank you Rudy but that's not what I am looking for.