I thought I had configured the various software corectly on an ASA 5505, but appears not.
In Show Version the ASA Software version is 8.4(4)1 & the Device Manager version is 6.4(9). These are the settings I want; I had previously set asdm image disk0:/asdm-649-103.bin & boot system disk0:/asa844-1-k8.bin followed by copying the running config to the startup config
When I boot the system & open a browser to the device I immeadeatley get a screen showing Cisco ASDM 6.2(1). How so?
If I attempt to install, run ASDM or Run Startup Wizard nothing happens - browser times out.
I suspected that maybe I needed the device to trust my PC, so I enabled HTTP & tried to setup the trust with my PC. After HTTP Server enable I entered http 192.168.1.0 255.255.255.0 mgmt, but received an invalid input on the mgmt, I don't know what the correct command is now.
So i'm confused. Do I have the correct version of ASDM installed & is it available when I boot the system?
Is my PC able to access the site to manage the device via the ASDM tool?
"mgmt" would specify that you are allowing clients on network 192.168.1.0/24 access via the mgmt interface. A 5505 does not have a dedicated management interface, thus the syntax error.
Any number of things could prevent your ASDM from launching correctly. Incorrect encryption settings or lack of 3DES-AES license, missing binary or incorrect file name, and incorrect management settings to name a few.
We have the Endpoint purge to delete any thing over 365 days, but this wasn't working as standard since in was installedSo disabled and enabled again and this seem to fix it, as had just under 200k endpoints captured. But it removed all clients that ...
When we unregister FTD from FMC and re-register, all the static routes are lost on it. Sometimes device has database corruption, if re-image is the only solution then upon re-image, FTD comes up fresh and we need to configure everything from scra...
Hi,I have a very simple question; we have two ASA 5585-X working in Active/Standby Mode with multiuser Contexts.Normally Primary Unit is active for failover group 1 and 2; Secondary Unit is standby !At the moment our Secondary Unit is completely disconnec...
Meet the Authors Event - CCIE Security and Practical Applications in Today’s Network: Zero Trust
(Live event – Thursday, 29th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 6:00 p.m. Paris)
This event will have place on Thursday 29th, October 2020 at 1...
My company uses Microsoft Azure AD, and I sign into all my applications using that account. Can I use that account when I sign in?
Yes - all applications that support SecureX sign-on allow direct login with your Microsoft Azure AD accou...