Network Security

Guys ..Do you have any idea / experience with ASA redundanci (failover active / active, failover active / standby). How about the management ?What is the best practice to manage the ASA (first ASA and secondary ASA) ?Can we use the interface manageme...

I need to configure the following on my PIX:TCP port 2195 - outboundTCP port 2196 - inboundHow would I configure this via ASDM?

Hi All,I am having issues with the ASA 5510 management interface.I can't communicate with this interface. It is showing DOWN/DWON evenif I type NO SHUT several times.My existing config is as followsour-asa-01# sh run: Saved:ASA Version 7.2(5)!hostnam...

I am fairly a newbie to the ASA 5505, and I'm currently only familiar with ASDM to configure this thing until I get some classes under my belt.My question is this... We have a 5505 and I have configured a separate inside and guest network. Vlan 4 is ...

hi all,It was first time I tried to turn on priority qos on 8.4 soft and modified the buffer size but when wanted to check strange values were displayed. ASA(config)# show priority-queue configPriority-Queue Config interface outside current         d...

I have a cisco ASA configured for AnyConnect clients.  I also want to pass 443 traffic back to an internal web server, but not sure if I can do this since the AnyConnect clients are already connecting over 443 to the ASA, right?

I am a little uncertain if I am required to do anything else.  Or perhaps I am misunderstanding and the Identity cert doesn't need the same trustpoint as the CA cert?I get a FAIL message when I run the crypto ca authenticate command for my certificat...

Hi ,I have ASA5585 in routed mode (Check the attached diagram) , and my DHCP client on the inside , while the DHCP server is on the outside.I know that ASA can be configured as a DHCP relay , but there is a condition “DHCP clients must be directly co...

i has ASA 5520 that has no any OS images in it's flash disks, and i want to boot it first from the tftp then copy this image to flash disks ( if the tftp boot suc ) and i did the below config :---------------------------------------------------------...

Dear all,we have cisco ips Version 7.0(2)E4 recently its analysis engine stopped working , folowwing is the logs for the IPS devices and also please check the attached screen shot for detail.# show healthOverall Health Status                         ...