Having a switch from Cisco: SG300-52, It functions only from a web gui, no cli available which has made configurations cumbersome.
We don't see a tab for assigning an IP Address to a VLAN under "VLAN Management".
This document will attempt to track known reasons and workaround/fixes for this error.
Our intended goal via the web gui is: Switch(config)#interface Vlan2 Switch(config-if)#ip address 10.x.x.x 255.255.255.0
Switch runs in Layer 2 mode by default. If we want to put ip addresses on the vlans, need to change the switch mode from Layer 2 mode to Layer 3 mode. We can ONLY do this in the console menu (not the web GUI). It does indeed exist, you must access it using a baud rate of 115,200 (not the standard 9600), data bits = 8, parity = none, stop bits = 1, flow control = None. It is also available via telnet (default username/password is cisco/cisco). Go to Switch Main Menu --> System Mode.
NOTE: Switching between Layer 2 & Layer 3 modes will clear all other configurations that you have in place, so plan accordingly.
You should be able to address the vlans after you've made this change.
Hello,I am looking at replacing an old site router (non-Cisco) with a Cisco C1111-8PLTELA. Due to the remoteness of the site they aren't able to get a high bandwidth WAN connection, so currently they are using 4 (2x LTE 2x VDSL) and the existing rout...
Hi Guys,When I plug in my switch the system LED is blinking green and all the ports led lit up for a few seconds then the ports led goes off, and a few seconds after the system LED is off. The switch seems like its shutdown after. Any ide...
I am trying to ping Loopback interface IP from PE Router in Underlay SDWAN vpn 0. But its not Pinging from either side.we are using Static Routing between PE and vEdge.is there anything special we need to do?
I have a Cisco ISR 4451-X running version 16.8.1 (Fuji) and I'm trying to configure a couple of 24-port SM-X-ES3-24-P (running 15.0(2)EJ) into it using BDI. THIS document says to use the commands below. However, in v16.8.1, #3 is not a valid command on th...
dear alli have :c2900-universalk9-mz.SPA.154-3.M1.bin" (Cisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.4(3)M1, RELEASE SOFTWARE (fc1)) with memory as belowCisco CISCO2911/K9 (revision 1.0) with 483328K/40960K bytes of memory.Processo...