Border Gateway Protocol (BGP) does not perform load balancing by default.
Load sharing is a concept that allows a router to distribute the outgoing and incoming traffic among multiple paths. The paths are derived either statically or with dynamic protocols, such as RIP, EIGRP, OSPF, and IGRP. By default, Border Gateway Protocol (BGP) selects only a single best path and does not perform load-balancing.
hello everyone, I need help to configure my cisco 800 series router with pppoe.i got internet from my isp , they provided me with ppoe credentials and thei zte ont router.i asked them to make zte router as bridge in order i can configure my router wi...
Hi all,hope you can help me.I've spent the entire day trying to figure out what is wrong and can't seem to understand the issueI have a system with several Ciscos 3650 Switches, I configured Auto RP on all the switches (for redundancy), and gave pri...
I need to copy running-config from R1, R2, S1, and S2 to PC-B with tftp. It works fine for every device, except for S1. I am able to ping PC-B from S1, but I am unable to ping S1 from PC-B. Any help is appreciatedThank you
Hello,I try to play around with Packet Tracer and channel-groups.I added 2 c2960 switch and both gi Ports are channel group mode on.When I shutdown gi0/1 I could still ping the other switch. But when I add no shutdown, I could see, that both connection go...