I have attached a document to show our BGP topology with our ISP. We have a FR Circuit from our ISP to Corp Office and a FR circuit to our Production location. We had a major outage when our Production FR circuit went down and it impacted our end users. Working with the ISP, we went with a BGP config to re-route traffic from router FES02 over to FES01 into Corp router, across the p2p T1 into the Prod router. At the time of implementation, it was tested and worked.
We recently had another outage and this time BGP failed. What are some troubleshooting methods I can do on my side to validate that the BGP config is working properly? I have checked some standard show commands and things appear to be ok but I do not know BGP well enough to make sure I am looking at the info properly.
Also, what steps do I need to complete to enable BGP debugging AND have the router display the activity real time?
Below are the summary outputs
# sh ip bgp summary BGP router identifier 172.19.17.223, local AS number 64515 BGP table version is 23, main routing table version 23 4 network entries using 468 bytes of memory 6 path entries using 312 bytes of memory 6/4 BGP path/bestpath attribute entries using 744 bytes of memory 2 BGP AS-PATH entries using 48 bytes of memory 0 BGP route-map cache entries using 0 bytes of memory 0 BGP filter-list cache entries using 0 bytes of memory BGP using 1572 total bytes of memory BGP activity 6/2 prefixes, 21/15 paths, scan interval 60 secs
#sh ip bgp summary BGP router identifier 172.19.17.224, local AS number 64515 BGP table version is 13, main routing table version 13 4 network entries using 468 bytes of memory 6 path entries using 312 bytes of memory 6/3 BGP path/bestpath attribute entries using 744 bytes of memory 2 BGP AS-PATH entries using 48 bytes of memory 0 BGP route-map cache entries using 0 bytes of memory 0 BGP filter-list cache entries using 0 bytes of memory BGP using 1572 total bytes of memory BGP activity 4/0 prefixes, 10/4 paths, scan interval 60 secs
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd
Hi there! I am having issues with tunnels flapping across sites on our network, our network is airgapped and we use the customer's already in place network as our backbone to communicate across sites. I have combed left and right through everything I...
El escenario es establecer VPN Site to Site, basada en IPSec (aplicando Virtual Tunnel interface) utilizando un arreglo HSRP, adicionalmente se debe emplear la estrategia router on stick (es decir usar una interfaz del router para todas las acciones). Los...
Is there any way to add an unmanaged device device to topology diagram in DNA Center and manually add a link.For example I have an Anchor wireless LAN controller connected to a DMZ switch behind a firewall connected to the core switch. Currently the Ancho...
Hi Cisco Folks,I’m a L3 guy who is struggling to understand a L2 configuration. I need a sanity check to make sure I understand how my devices are configured. I have two Cisco switches (running IOS XR 6.6.12) connected by a Bundle-Ethernet interface ...
Hi, I have some Catalyst 9300 and 9200 switches in my park that need to update the license that has the provisional license. When we buy the equipment, we also acquire the licenses. I would like to know how do I update these licenses on these devices...