The encapsulation option does not show up when trunking is configured on a trunk port in the WS-X6148-GE-TX module. This is because the encapsulation option is enabled by default.
Two trunking encapsulations are available on all Ethernet ports:
Inter-Switch Link (ISL) is a Cisco-proprietary trunking encapsulation.
Note: The WS-X6148-GE-TX switching module does not support ISL encapsulation.
802.1Q (or dot1Q) is an industry-standard trunking encapsulation.
A trunk can be configured on a single Ethernet port or on an EtherChannel.
The trunking mode, the trunk encapsulation type, and the hardware capabilities of the two connected LAN ports determine whether a link becomes an ISL or 802.1Q trunk.
Ethernet trunk ports support several trunking modes. As the WS-X6148-GE-TX switching module does not support ISL encapsulation, the 802.1Q encapsulation is configured by default. So the dot1Q encapsulation is not available when trunking is configured on a trunk port in the WS-X6148-GE-TX module.
To display the administrative and operational status of a switching (nonrouting) port, issue the show interfaces switchport command.
We have a device connected to a 3650 switch whose ethernet controller crashes when it receives more than 200000pps. The traffic to this device can have variable packet sizes, so it would not be practical for us to rate-limit by mbps. Is there an...
if we enable mls Qos command on a C3560, by default, all ports are untrusted + COS override:dis + default COS:0. if we have the below, what will be the QoS value at the egress? Untagged frame (Access port connect PC) - at egress will be COS:0???...
New to IPv6? Trying to wrap your head around concepts like IPv6 addressing, solicited-node multicast, and just how, exactly, does all this work without ARP? Never fear, Fish Fishburne is here to help with this blog series she wishes had been out there whe...
I am a novice network guy. If I have missed something obvious, please let me know. I have a N520-20G4Z-A and using SFPs only in ports 4,5,6, and 7 - Port 7 won't come up. There are no other connections to the router. The f...
I am trying to figure out an issue with Small packets (sub-200Byte) which caused firewall performance issue and so far I can only pin point to the 4507 LAN switch doing the fragmentation...Standard MTU1500 is in use though. From "show ip traffi...