Cisco Digital Network Architecture Center Modules (Design Module)Part.3
In this article, we are going to talk about the Cisco Digital Network Architecture Center design Module.
Cisco DNA Center gives us the flexibility and scalability to configure multiple fabric sites and manage all of them through DNAC (Centralization Point).
The continuity of IT operations is the basis of today’s business environment. Almost every single decision made by the business is either based on IT data or done using the IT platform. And so, the Design, security, availability, and performance of the IT infrastructure are the key foundation of a solid business and service environment.
In the previous article we spoke about device credentials and today we are going to write about [Ip address Pool].
The Ip address pool services used to create a separate pool for each Subnet and there are two types of the pool, Type 1 is Generic type supporting for IPV4 and IPV6, Type 2 is tunnel type supporting for IPV4 only.
Note: Recommend to use type 2 for assign IP address for Site to site VPN.
How to configure Ip address Device Pool Services?
Design > Network Settings > IP Address Pools.
Add Ip Pool include [ Ip pool name –Type of the pool – Ip address space – Ip subnet –Netmask- Gateway Ip address – DNS Server ] SAVE
Note: DNA Give you options to choose your CIDR Prefix.
How to export Ip address pool from Cisco DNA center
Design > Network Settings > IP Address Pools > choose the pool > Action > Export.
How to import the ip address pool to Cisco DNA center
Design > Network Settings > IP Address Pools > Action > import from CSV File.
Note: you can download file format from DNAC.
*** I hope that has been informative for you and thank you ***
Hi ,In right now study for CCNA exam and during my lab practices i have configure NAT overload on both Router after I able to configure ping is not working ! kindly i need you support to know were my missing configuration or mistake .On attachment i...
We are using DNA Center to deploy SD-Access.I have a question as follows,The DNA center had hardware failure and We didn't back up the DNA Center config file.(only have one DNAC)What is the procedure to next when DNA Center RMA back?&nbs...
When I try to access the webserver from PC7 (see screenshot), I am given a "server reset connection" error. Upon checking the packet, I observed that the router RTR-1 is swapping the Destination IP address with the Souce IP address. Is there a way to fix ...
I've got a 2Mbps mpls link as a VPN 0 transport on a vEdge 100m. Carrier drops ALL traffic it receives above 2Mbps. I want to treat all traffic the same but simply want it to get across the mpls link and not get dropped. I thought I could accomplish this ...