route-map ISP1-NAT permit 10 match ip address 1 set interface FastEthernet0/0 ! route-map ISP2-NAT permit 10 match ip address 1 match interface Dialer1
line con 0
line aux 0
line vty 0 4
scheduler allocate 20000 1000
Router#sh ver Cisco IOS Software, 1841 Software (C1841-SPSERVICESK9-M), Version 12.4(15)T12, RELEASE SOFTWARE (fc3) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2010 by Cisco Systems, Inc. Compiled Fri 22-Jan-10 00:40 by prod_rel_team
ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Router uptime is 17 hours, 21 minutes System returned to ROM by reload at 11:24:31 UTC Mon Oct 11 2010 System image file is "flash:c1841-spservicesk9-mz.124-15.T12.bin"
This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. Importers, exporters, distributors and users are responsible for compliance with U.S. and local country laws. By using this product you agree to comply with applicable laws and regulations. If you are unable to comply with U.S. and local laws, return this product immediately.
If you require further assistance please contact us by sending email to firstname.lastname@example.org.
Cisco 1841 (revision 7.0) with 235520K/26624K bytes of memory. Processor board ID FHKXXXXXXXX 3 FastEthernet interfaces DRAM configuration is 64 bits wide with parity disabled. 191K bytes of NVRAM. 62720K bytes of ATA CompactFlash (Read/Write)
I am a student, and learning Switching, Routing, and Wireless Essentials I have a question about configure a Router-on-a-Stick routing As we can see, We have 5vlans and 3 switch. I configure etherchannel between S1 and S2.How can I con...
Hi,I am struggling with my networking lab project, I'm familiar with the commands to apply but I can't quite figure out on which devices they should be applied on as I have tried lots of scenarios with no luck.- I need to configure spanning tree between t...
New Cisco Champion Radio release on Cisco Smart Building SolutionsListen: https://smarturl.it/CCRS8E16Follow us: https://twitter.com/CiscoChampion Now more than ever, sustainable and flexible building designs are at the forefront of every develo...
Hi I am trying to monitor the Cisco DNAC node health status using the monitoring capabilities (System > System 360 > Monitoring) comes with Controller. Like to trigger an alert (Grafana alert) if the node is unhealthy and not part of the ...