There is no command to disable the reserved power for an empty slot.
The power allocated for an empty slot is non transferable, for example, it cannot be selectively or preferentially allocated to other slots or modules. The process of power redistribution happens automatically and in a particular order pre-defined by the supervisor.
In order to display the per slot power Requirement/Usage, use the show environmentall command.
Hello experts, We had an ASR1001-X running IOS 16.6.4 and we were using the hidden command "hw-module subslot x/x statistic poll-interval 1" to be able to monitor via SNMP every second (default is 5 secs). This command was working fine (we watched it...
Why massive traffic to social media do not cause DOS/DDOS attacks? Billions of people accessing the servers of social media then why still it is not going down as DOS or DDOS attack would do by overhwelming network bandwidth and resources?
Hi Can i have two etherchannels on one switch with the same number (so both groupchannel are number 1) or i need every channel to be uniqe and if so how is it possible if the number range of the groupchannel is 1 - 5
Hi, I am trying to configure eBGP between two routers, the routers are not directly connected to each other but have reachablity via static routes. I have configured the bgp neighbor-ship between the two routers and it's up. On the routing table...
We would like to build a site to site vpn between our HQ and a branch office. The branch office has a firewall as default gateway to the internet connected to a DSL line. The VPN router (ISR931) should be connected to the firewall with a single interface....