On most class B Flash file systems, you can partition banks of Flash memory into separate, logical devices so that the router can hold and maintain two or more different software images. This partitioning allows you to write software into Flash memory while running software in another bank of Flash memory.
To partition Flash memory, you must have at least two banks of Flash memory. A bank is a set of four chips. This requirement includes systems that support a single SIMM that has two banks of Flash memory. The minimum partition size is the size of a bank.
This command is an example of how to partition Flash memory:
This task succeeds only if the system has at least two banks of Flash, and the partitioning does not cause an existing file in Flash memory to be split across the partitions.
For all platforms except the Cisco 1600 series and 3600 series routers, Flash memory can only be partitioned into two partitions.
For the Cisco 1600 and 3600 series routers, the number of partitions that you can create in a Flash memory device equals the number of banks in the device. Issue the showflash-filesystem: all command to view the number of banks on the Flash memory device. The number of partition size entries you set must be equal to the number of specified partitions. For example, the partition slot0: 2 8 8 command configures two partitions to be 8 MB in size each. The first 8 corresponds to the first partition; the second 8 corresponds to the second partition.
We are testing the setup capabilites on IOS-XE (on CAT9200L and 9300L) and it was working great with IOS-XE 16.12.05b (cat9k_lite_iosxe.16.12.05b.SPA.bin) But with 17.03.03 (cat9k_lite_iosxe.17.03.03.SPA.bin) we get following error while booting...
Hello all, i've configured my new cisco switch 9200i've put the fibre port in trunk mode, allow all vlans, etc.in the 3750x i can ping it and from all 2960s/x i can ping it to however when i try to ssh or use the webgui it says "connection time ...
We are using Prime Infrastructure 3.9.0 with all installed fixes and Device Pack 1.We set up Meraki Dashboard integration according to this two guides:https://documentation.meraki.com/General_Administration/Other_Topics/Cisco_Prime_Infrastructure_Integrat...
Hello Cisco experts, I have a Cisco switch (3750) that is having an issue when selecting options under port configuration. I am able to access all other sections/options fine, but when I select to set a port and putting in a description and att...
If anyone knows, please let me know. Does it work at 1000mbps when using 10G sfp + with C9300-NM-8X? Also, with that configuration, is it possible to connect when the opposite device has a 1G-LX interface?