Enhanced Interior Gateway Routing Protocol (EIGRP) is a Cisco proprietary enhanced distance vector routing protocol, relying on the Diffused Update Algorithm (DUAL) to calculate the shortest path to a destination. It functions by discovering neighbors, exchanging routing information with them and installing the best routes in the routing table. It speeds up convergence by storing backup routes in the topology table and using them when the primary route fails. These are the most common EIGRP issues:
Failure to form neighbor relationship with other EIGRP neighbors on the same segment.
Routes missing from the topology table or routing table.
Routes not being redistributed into EIGRP.
EIGRP routes stuck in Active state.
Load balancing not working properly.
User receiving EIGRP Not On Common Subnet error messages.
User can ping but cannot telnet across a Frame Realy network.
The issue is mostly related to configuration errors such as these:
Packet filters and route filters denying EIGRP packets and routes.
Split-horizon functioning over Non-Broadcast Multi-access (NBMA) networks such as Frame Relay and ATM.
Missing broadcast keyword in Frame Relay and ATM map statements.
Misconfigured IP addresses.
Improper configuration of variance.
Frame relay header compression is on only on one side of the network.
To resolve the issue of a user being able to ping but not telnet across a Frame Relay network, issue the debug telnet and debug ip tcp transactions commands on both sides. If the debug shows that it is receiving bad segments from the the other side, you can take a look at the configuration. There is a possibility that Frame Relay Header Compression is turned on only on one side of the link. If this is the case, turn off header compression to solve the problem.For information on other issues, refer to these documents:
On the official data sheet it says this: This is incorrect, though. I have a 3750x-24T right here and it's using a steady 42 watts. Given that Cisco's posted number is more than double what I have right in front of me, it would seem that ...
I can't connect to the Internet, my router is Cisco 881, I have an OpenWRT router connected to internet which has the local address 192.168.1.1 and distributes addresses with DHCP - he just working great. I connect in this way:internet => openwrt...
PE-1 is advertising routes to PE-5 via MP-BGP. Route-target import has not been configured on PE-5 for VRF TEST although routes are being received and installed in "show ip bgp vpnv4 all" but not not being installed in show ip bgp vpnv4 vrf TEST.&nb...
Hi, Does anyone can guide me about the following DNA license subscriptions for PnP accounts: 1-How much bandwith for vEdge devices is allowed with Essential, Advantage, and Premier subscriptions?2-What are the time durations for a different subs...