To change from a switch prompt to a module prompt, such as a router module, the sessionmod command or the switch consolemod (on Catalyst 6000 series switches) command may be issued.
When issuing the sessionmod number command, first issue the show module command to determine the module number for which you need access. In the following example, the Multilayer Switch Feature Card (MSFC) is module 15. The session 15 command connects the session to the MSFC. In order to go back to the Supervisor prompt after issuing the session command, the exit or logout command must be issued at the MSFC's prompt.
Console> (enable)show module
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1 1 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes ok
15 1 1 Multilayer Switch Feature WS-F6K-MSFC no ok
2 2 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes standby
4 4 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok
Mod Module-Name Serial-Num
--- -------------------- -----------
Console> (enable) session 15
Connected to Router-15.
Escape character is '^]'.
The switch consolemod command is only supported on the Catalyst 6000 series switches. In order to switch back to the Supervisor prompt in this mode, hold down the Ctrl key and press c three times. The exit or logout command does not work when the switch console command has been used to gain access to another module. If only one MSFC is installed, the module number does not need to be specified.
Console> (enable) switch console
Connected to Router-15.
Type ^C^C^C to switch back...
Hi Dear Friend I have Router ASR1002 by multi Bgp Session Now i want if bgp peers announce prefix to me for exampleannounce prefix 192.168.0.0/24 to me My ASR 1002 Allow Forward TX traffic (send) by this Source From own automacticlly any prefix announce t...
Hi,I have server DNA Center version 22.214.171.124 is a single node, Two Border Node C9500-16X add in DNAC with DiscoveryI have a Switch Edge Node C9300L-24P-4X add in DNAC with LAN Automation Everything is good right NowIN Fabric Domain site when I click on Bor...
Hi all guys,I have a simple static NAT config.TopoClient (f0/1) ----192.168.0.0/24----(f0/1)R1(f0/0)----126.96.36.199/24----(f0/0)R2IP addressesIP Client:f0/1: 192.168.0.10/24IP R1:f0/1: 192.168.0.1/24f0/0: 188.8.131.52/24IP R2:f0/0: 184.108.40.206/24 ConfigCli...
Hi,I am setting up a cisco packet tracer to have 6 separate vlans. I have 2 PC's in each vlan connecting to a 2960 switch, each switch is further connected to one 2960 switch which is connected to a 3560 Layer 3 switch. Each vlan (the PC's) has a differen...