Microsoft network load balancing basics

1354

Views

Helpful

Comments

edited on: ‎03-01-2019 ‎05:01 PM

This document covers the basics of microsoft network load balancing(NLB) in the unicast and multicast modes and their configuration , it also provides a little platform specific information for NLB on catalyst switches.

Latest Contents

High Availability For 3650 Catalyst Core Switches

Created by Abdel-Nasser on 07-16-2019 11:45 PM

Hello Everyone I have the topology which attached in the discussion.As shown in the topology I used two Catalyst 3650 as core switches, also I used SVI to allow VLANs to communicate. Besides, I used rpvst to make high availability in case one of the ... view more

err-disable

Created by Bhawani_Singh on 07-16-2019 10:06 PM

Hello,I have a cisco 2960 plus series switch and an SFP module. When I plug SFP in port the port goes in err-disable. After a shut, no shut the port's LED blink for once and it goes down again and the following message appears on the terminal. ... view more

whats the source IP router will take from its interfaces IPs...

Created by sudiptabhar on 07-16-2019 09:32 PM

Facing a PING issue as described:A router has 2 IPs on its 2 interfaces :(1)192.168.1.1/24 & (2)2.1.1.2/30;Now when pinging an external IP from the router, which will be the source IP, the router will add in the packet ?192.168.1.1/24 or 2.1.1.2/30 ?b... view more

HSRP and spanning tree

Created by Steven Williams on 07-16-2019 09:07 PM

What are some “gotchas” with hsrp and spanning tree? I have read that you should use a layer 3 link between the hsrp routers but I can’t seem to wrap my brain around that. How does that work? Also your active router should have its vlans set for active se... view more

OSPF vs vPC, which solution is the best / more stable?

Created by ปลาวาฬทราย RMUTT CPE IX on 07-16-2019 08:27 PM

Thank you very much.