This script implements multiple pipe support from the IOS command line.
Script Modified Date:
Aug 17, 2010
Cisco IOS Version tested:
Cisco Products Tested:
Environment Variables used:
Script Info URL:
How many times have you wanted to do "show run | inc snmp | redirect flash:/snmp.cfg"? Up until now this wasn't possible because IOS only supports one pipe. The other pipes are treated as part of the argument to the first pipe command. The cl_multi_pipe.tcl EEM policy enables the support for multiple command pipelines. You can run as many pipe commands as you want.
Hi, I am struggling with the setup of the WLC 9800 on a Catalyst 9300 Switch. I would like to configure it from DNA Center but I think DNA Center is not aware that I have one.Here is the output from my switch Next reload AIR license Level: AIR DNA Ad...
Hi all, I’ve been reading up and SPAN and the use of aggregator taps and full duplex taps. I feel i have a better understanding of each, but i still have a question that cannot seem find the answer to, hopefully somebody will know the answer to...
Dear All , I am doing my thesis on Segment Routing and trying to show the benefits of SR by using GNS3 and building a network and implementing SR and testing some use cases I'd need your help and suggestions the network is as shown below &n...
Hi All and thanks for any clues or solutions. First Issue My VPN setup seems to work ( Connects fine to my Iphone and Ipad) even with some issues in the log !! ?? Should I just ignore those ?? %CRYPTO-6-IKMP_MODE_FAILUR...
Hi, I'm testing a dual cloud dmvpn as a backup for mpls. Dmvpn using ibgp and mpls using ebgp between hub and spokes. Each Cloud has single hub and these two hubs sharing same DC LAN Network subnet and using eigrp in DC.Each huB has one mpls li...