Hello, yould you help me please with the problem ? We operated the Unifi U6-LR AP on the Zyxel XGS1930-28HP without any problems. We replaced the switch with a Cisco SBS350-48-4X. The access points use native VLAN 1 for management and other communica...
view more
Hello all. I'm trying to update the FW on to Switches I obtained from 12.2 to 15.0 since its the only one I can obtain without a contract. The switch says its an IP Base in the "Sh Ver" command however when I try to update the firmware I get an error sayi...
view more
Hi guys,
I have a default route which is tracked, the track is up, but the route is not being placed in the routing table. I copy only the relevant configuration:
!
track 1 ip sla 1 delay down 9 up 3
ip route 0.0.0.0 0.0.0.0 10.20.15.1...
view more
Hi there.Recently I upgraded a Cisco catalyst switch with the IOS version 16.12, following which smart licensing was enabled. The question is what happens if I do not want to activate it and what happens to the switch and its functionality once its expira...
view more
Hi all, Very basic question but essential for me (since I don't have the hardware in front of me).Can someone tell the interface numbering on a 3560-24TS (the copper ports). The front panel doesn't give me any clue whether the interface n°0 is t...
view more