In addition to a reset of the CONFIG_FILE ROMmon variable, purge the NVRAM contents to avoid the passage of any corrupt files from Hybrid.
Issue these commands from the ROMmon privileged mode in order to purge the contents of the NVRAM:
rommon 1 > priv rommon 2 > fill Enter in hex the start address [0x0]: be000000 Enter in hex the test size or length in bytes [0x0]: 80000 Enter in hex the pattern to be written [0x0]: ffff Enter the operation size 'l'ong, 'w'ord, or 'b'yte [ ]: l rommon 3 > reset
Hi, Good day! As per checking usb port in our 2960-x network switch is disabled, Is there a specifc command to enable it? Thanks! OOB_SWITCH#show usb portPort Number: 0Status: DisabledConnection State: DisconnectedSpeed: FullPower State: ON...
Hello,We have a case where a customer has upgraded the IOS for his C3850 to a version higher than 16.9.1.He was not aware that he had switched on Smart Licensing.Let's assume the customer had bought this equipment in 2018 with the permanent IP Base licenc...
Hello, Hope you all are doing well. I'm having issue with MPLS L3 VPN where I'm not getting ping reply from one CE to another CE where as routes are present in CE of another CE's. the IGP on the backbone is OSPF and using EIGRP to communicate be...
What would be the best way to filter route advertisements from and to a BGP neighbor with keeping flexibility in mind in case requirements change in future? Would it be just to create prefix-list then apply that to a route-map?