The console displays the %SYS-6-READ_BOOTFILE_FAIL error message during the boot. After timing out, the router drops into boot mode.
To resolve this issue, perform these steps:
Check the Network Processing Engine (NPE) version. The Flash disk is only supported as the primary boot media for NPE-225, NPE-300 (EOS), NPE-400 and Network Service Engine-1 (NSE-1) based systems.
Use the Flash disk side by side with linear Flash memory for NPE-200 and earlier systems. Although it is possible to boot from a Flash disk, a bootable image must be maintained on a linear Flash memory card. This is to ensure that the router is bootable if the bootflash software image becomes unusable.
Verify that the Cisco IOS Software version is compatible. The Flash disk is only supported on systems with the Cisco IOS Software filesystem feature. In general, the Flash disk functionality requires Cisco IOS Software Release 12.0 or later.
Note: For the Cisco 7200 series router with an I/O controller card, the minimum supported releases for the Flash disk are 12.0(3)T, 12.0(5)S, 12.1(1)E, 12.1(1)T, 12.1(1), 12.2(1) and 12.2(4)B.
Hi Experts I am trying to set a sort of L2VPN between two vEdges using the Bridge functionality, however i have not had success yet.I got the bridge interfaces up on both sides , and also each of the laptops MAC addreses are being recognized, but jus...
Meet the Authors Event - Peter Paluch, Co-author of CCIE Routing and Switching v5.0 Official Cert Guide, Volume 1
(Live event – Wednesday, October 30th, 2019 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 6:00 p.m. Paris)
This will have place on Wednesday 30...
Hi All, I copied the config of an Old switch to configure a new switch but when I login through https:// IP into the new switch, its showing the old location, check the screenshot attached, Is there any command to add the new location of the sw...
Hi Team, my C3750 Switch restarted Twice today and i am not sure what caused the issue. i checked my Power Supply but did not find any issue. can somebody help me to figure it out the Root cause of the issue. show versionCisco IOS Software, C375...