This problem is caused by a failure to issue the squeeze command after deleting the file on the Flash.
After deleting files to free up space on a Catalyst switch with a Class A Flash file system, the squeeze operation must be performed to recover the space occupied by the files.
When a file is deleted by issuing the delete <device:> <filename> command, the specified file is marked as deleted, but continues to occupy the space on the Flash device.
To recover the space, issue the squeeze <device> command. This command permanently deletes any files on the device that have been marked as deleted. The squeeze operation may take a while, depending on which files are deleted and their position on the Flash device.
Note: If the device is an ATA FlashDisk, the squeeze operation does not apply.
The delete command permanently deletes the file on Flash disks.
This output is an example of deleting and squeezing a configuration file from bootflash:
Router# show bootflash -#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name
25987056 bytes available (6780944 bytes used) !-- The space is still taken up by the file. Router#squeeze bootflash: All deleted files will be removed. Continue? [confirm] Squeeze operation may take a while. Continue? [confirm]
Squeeze of bootflash complete Router#show bootflash -#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name
Hi ,In right now study for CCNA exam and during my lab practices i have configure NAT overload on both Router after I able to configure ping is not working ! kindly i need you support to know were my missing configuration or mistake .On attachment i...
We are using DNA Center to deploy SD-Access.I have a question as follows,The DNA center had hardware failure and We didn't back up the DNA Center config file.(only have one DNAC)What is the procedure to next when DNA Center RMA back?&nbs...
When I try to access the webserver from PC7 (see screenshot), I am given a "server reset connection" error. Upon checking the packet, I observed that the router RTR-1 is swapping the Destination IP address with the Souce IP address. Is there a way to fix ...
I've got a 2Mbps mpls link as a VPN 0 transport on a vEdge 100m. Carrier drops ALL traffic it receives above 2Mbps. I want to treat all traffic the same but simply want it to get across the mpls link and not get dropped. I thought I could accomplish this ...