The "Error getting file system status (Invalid file header magic number)" and "%Error calling getden...
The "Error getting file system status (Invalid file header magic number)" and "%Error calling getdents for bootflash:/ (Invalid file header magic number)" error message appears in Catalyst 6000 / 6500 series switches
When you issue the show bootflash: all command in order to display information about the bootflash: file system, it only shows part of the boot flash information and at the end, the Error getting file system status (Invalid file header magic number)error message appears.
This is due to bootflash corruption. This happens sometimes when a crashinfo file written due to crash into bootflash and later on a file is copied after this crashinfo file.
In some scenarios, when you issue the dir bootflash: command, you receive this error message:
%Error calling getdents for bootflash:/ (Invalid file header magic number)
No space information available
In order to overcome this error message, the bootflash needs to be formatted and required files needs to be copied again.
This can be done by the format bootflash: command. Then copy files from the disk in order to recover the Flash Memory.
Note: Always be careful while you format the Flash device. If the Multilayer Switch Feature Card (MSFC) is reloaded before a new image is downloaded, you must recover the MSFC with Xmodem.
We have an older 6509 chassis with WS-F6K-DFC4-E module installed. The 6509 is EoL, EoS and is slated to be replaced shortly. However, we still need to add additional 10G connections before the hardware can be replaced. When we adde...
HI All, Please reffer the attached topology HUB location: 1 Core router / 2 CE routers connected to respective MPLS service providers.HUB Connectivity details: all 3 routers in the HUB are connected via IBGP and 2 CE routers connect to MPL...
Hi all, I know this may be a long shot, but has anyone tried using the 10G-T-X (Copper) module in the 9200L series switch? (Currently not listed on the supported SFP list) We have a need for a short copper run and our desire would be to nix the ...
We are testing the setup capabilites on IOS-XE (on CAT9200L and 9300L) and it was working great with IOS-XE 16.12.05b (cat9k_lite_iosxe.16.12.05b.SPA.bin) But with 17.03.03 (cat9k_lite_iosxe.17.03.03.SPA.bin) we get following error while booting...
Hello all, i've configured my new cisco switch 9200i've put the fibre port in trunk mode, allow all vlans, etc.in the 3750x i can ping it and from all 2960s/x i can ping it to however when i try to ssh or use the webgui it says "connection time ...