%GBIC_SECURITY_CRYPT-4-VN_DATA_CRC_ERROR: GBIC in port [dec] has bad crc.
This message means that the Gigabit Interface Converter (GBIC) module is identified as a Cisco GBIC module, but it does not have a valid cyclic redundancy check (CRC) in the EEPROM data. [dec] is port number or the interface in which the module is installed.
Even if the GBIC module is unrecognized by the system, the GBIC module can still operate properly, but it has limited functionality.
This problem is also termed cosmetic, indicated in Cisco bug ID CSCse25214.
Note:Cisco-approved Small Form-factor Pluggable (SFP) modules have a serial EEPROM that contains the module serial number, the vendor name and ID, a unique security code, and CRC. When an SFP module is inserted in the switch, the switch software reads the EEPROM to verify the serial number, vendor name and vendor ID, and recompute the security code and CRC. If the serial number, the vendor name or vendor ID, the security code, or CRC is invalid, the software generates the security error message and possibly places the interface in an error-disabled state.
In order to resolve this, verify that the software release that runs on the system supports the GBIC module. If the GBIC module is newer, a system software upgrade is possibly required.
Hi all, I have a new Cisco FirePower 1010 that I have configured for a small remote office. I have most of what I need working including the S2S VPN Tunnel to an ASA 5515.Now, I'm trying to get Cisco APs to lite up over the tunnel and I need to configure ...
Working on setting up a pair of 9300s to be 1 of the egress points for the network w/ a backup site at another location. Currently i have the other location using the default-information originate command w/ a metric of 5 and that works w/o any issu...
Hi I can not figure out a method to get 2 layer 3 switches which are configured with ether channel to talk to 1 router in harmoney. Non of the nodes in the VLAN 10 ,100-129 can ping the router (router ip: 10.29.0.1) i have tried ip route. Any surgest...
Hello I was wondering if anyone knew if this Router was configurable in regards to authentication vlan from the ISP.My ISP uses vlan 3163 for auth on vdsl2 whereas my ISP uses 0/32 for adsl. Was curious if this was able to be changed to that or if th...
Have you ever wondered why pluggable optics exist? Have you ever wondered what acronyms like QSFP, LR4, FEC, and PAM4 actually mean? In this first episode I start a conversation with my colleague Ray Nering. He explains to me how a lot of these came to be...