This message indicates that the VLAN is configured with Private VLAN (PVLAN), and that the Router Access Control List (RACL) for this VLAN cannot be configured in the Policy Feature Card (PFC). The RACL is enforced in the Multilayer Switch Feature Card (MSFC) software.
A failure of the ACLs or VACLs to merge property, or they have run out of Ternary Content Addressable Memory (TCAM) space.
The ACLs may have failed to load in TCAM space due to a large number of ACLs or VACLs that need to be re-programmed.
The flexwan module does not support named ACL.
To resolve the issue, perform one of these procedures:
Remove the PVLAN configuration and re-attach the RACL to the VLAN to configure it in PFC.
If no PVLANs are configured, it is likely due to a failure of the ACLs or VACLs to merge property, or they have run out of Ternary Content Addressable Memory (TCAM) space. To avoid this, use the Order Dependent Merge (ODM) algorithm, which more effectively uses the TCAM space. Configure ODM on the supervisor module and the MSFC.
Hello, I've been banging my head against the wall as to how I can properly deploy QoS at our WAN edges for all locations. Specifically for controlling both upload and download speeds whilst allowing for proper queuing of voice/video traffic in...
Good day all, On a switch port with number of vlans, there is a vlan which is only used for a single device connectivity.No other ports in the same switch are on that vlan. (example- switch has vlan10,11 & 12 for users and there is a vlan2 w...
Host L1 is connected to switch sw1, Switch S1 is connected t Switch S2, Switch S2 is connected to Router R1, Router R1 is connected Router R2, Router R2 is connected to Host L2. How will communication happen from Host H1 to Host H2?Tell me the entire proc...
Hi there! We have an ASR 9001 that I'm wanting to better balance our outbound traffic for. Our setup is as follows Router -> Tier 1 ISP XRouter -> BGP peer with another public ASN -> Tier 1 ISP Y It was easy to balance the inc...
HelloIn the compatibility matrix tool of the C9500-24Y4C it indicates that it is compatible with the SFP GLC-SX-MMD and GLC-LH-SMD, it does not include the SFP GLC-SX-MM and GLC-LH-SM. I understand that the difference with the GLC-SX-MMD and GLC-LH-SMD SF...