The message indicates that the fan tray cooling is not sufficient. The power is denied to the respective module [dec] or line card mentioned.
The supervisor engine monitors the power consumption of the modules during boot. As the supervisor engine attempts to power up a module, it compares the module's power needs with the remaining capacity of the power supply. If there is not enough power supply capacity remaining, the supervisor engine does not power up the module [dec].
Issuing the show environment cooling command reveals the "Chassis per slot cooling capacity" required for the line card in cubic feet per minute (cfm) used for cooling.
For example, the line card WS-X6748-GE-TXrequires cooling capacity of 70 cfm, but if the chassis per slot cooling capacity is less than 70 cfm (which can be checked with command show environment cooling) then the power is denied to the line card.
In order for the Supervisor 720 to operate in all Cisco Catalyst 65xx chassis as well as Cisco 7603, 7606, 7613 and OSR-7609, an upgraded system fan tray is required to support the additional cooling requirements for these modules. Refer to this table for an outline of the requirements for each chassis (Table A).
Table A. Fan options for the Cisco Catalyst 6500/Cisco 7600 series Internet router.
Hi all, Im a beginner to CPT and i am hoping someone can assist me for an assignment coming up. I am having trouble configuring a DHCP relay from a DHCP server to a network consisting of multiple routers, with their devices on their own networks. The...
Hi,i have an issue related to firepower tab missing from the ASDM firepower module is up and sfr module also on the CLI everthing seems goodi tried to to reboot both asa and module sfr nothingcould you help please , i'm struggling with that problem&n...
I have deployed a linux server to ENCS with two interfaces "eth0" and "eth1" with IP addresses 10.0.10.132 and 10.0.10.133. There is an external router in my network as ERSPAN source generating traffic and configured to send ERSPAN to ip 10.0.10.133. What...
Cisco C9500-24Q upgrading stack from 16.6.04 to 16.12.04. The upgrades have been a success – everything is working fine, however following the upgrade I have acquired 192 tengiga ports in the interface list that weren’t there before (96 on each switch).&n...
Hi Alli've faced the usecase of ethanalyzer with decode-internal keyword on the N5548UP 7.0.7.N1.1 to findout the egress&ingress interfaces for the flow. Finally i've obtained something like below in packet header & now looking for ...