Simpler Segment Routing with NSO and IO...

536

Views

Helpful

Comments

Shelly Cadora wrote a blog post about rolling out Segment Routing in an LDP/ISIS network a while ago - apologies - should have posted here earlier... This is also a great post about network automation using NSO in general.

You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.

Comment

Latest Contents

new NSO install 5-2-1 and struggling with NEDs and package r...

Created by marioderosa2008 on 12-06-2019 09:21 AM

Hi team, i am new to NSO and im trying to follow labs and noticed that the cisco-ios package was not in my ncs-run directory... I found the packages in my install directory as below...cisco-ios-cli-3.0cisco-ios-cli-3.8 these are the two packages... view more

Read NETCONF RPC Additional Attributes

Created by mmollber on 12-05-2019 04:11 PM

Hi, Is it possible to add additional attributes in a NETCONF RPC request in addition to message-id? See the following example: <rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="1" some-attribute="0001"> Looking at... view more

NSO Developer Days US 2019: A Low Code Approach to Brownfiel...

Created by Nicklas Wagerth on 12-05-2019 01:07 PM

Dan Sullivan, Principal Solutions Architect A low code approach to brownfield service discovery in NSO

What to include in service template

Created by RichardD2 on 12-05-2019 09:14 AM

If i have configuration on a device that needs to configure two GigabitEthernet interfaces, what is the best practice to configure my template. Do I cut/paste the entire XML for both interfaces into my template, or should I think of this as I would run th... view more

NSO Developer Days US 2019: NSO In and On Kubernetes - Lab i...

Created by Nicklas Wagerth on 12-05-2019 07:43 AM

See the slides here

CreatePlease to create content

Simpler Segment Routing with NSO and IOS-XR