Problem on netacad ccna activity

[davitgakhokia]

Hello.CCNA Module 7.3.6 Activity -Switch It! is experiencing some errors.It gives wrong answers.Have someone experienced it ?

[wesleyneal742302244]

It is completely backwards... or I am reading something very wrong. I have mac OC in table as source and OE as destination so I click it only sends uni to OE ...Cisco says this is wrong and says it adds to table and floods ports....

[dgakhokia98]

Yes,answers is always completly opposite of right answer.

[Martin L]

this is via a browser, right?  Try Incognito mode mode / Private or different browser.

send us a link

Regards, ML
**Have fun labbing!!!***
***Please Rate All Helpful Responses ***

[dgakhokia98]

I'll check it.

[dgakhokia98]

Changed nothing.Still gives wrong answers as right.In last problem of switching,switch mac address table knew every mac of connected port,answer still says that switch will flood the frame.when where is a empty mac address table,it says that it's unicast frame and will be sent to a specific port only.

[davitgakhokia]

Not working.

[wesleyneal742302244]

Tried it in new browser, it worked once, then next problem same issue...in incognito there was no change. Weird..

[wesleyneal742302244]

It worked once with a new browser then went right back with next question. Going incognito changed nothing.