7507 Error message :

guicong.yang · ‎10-22-2002

7507 boot Error message: who has this situation before ? how I can process it ?

(7507 : RSP2 slot1: VIP4-80 ( pa-mc-8e1) )

rsp-isv-mz.122-8.T5.bin

7507#show ver

Cisco Internetwork Operating System Software

IOS (tm) RSP Software (RSP-ISV-M), Version 12.2(8)T5, RELEASE SOFTWARE (fc1)

TAC Support: http://www.cisco.com/tac

Compiled Thu 20-Jun-02 18:28 by ccai

Image text-base: 0x60010948, data-base: 0x61800000

ROM: System Bootstrap, Version 11.1(2) [nitin 2], RELEASE SOFTWARE (fc1)

BOOTLDR: RSP Software (RSP-BOOT-M), Version 12.0(23), RELEASE SOFTWARE (fc1)

7507 uptime is 3 minutes

System returned to ROM by reload at 03:10:00 UTC Sat Jan 1 2000

System image file is "slot0:rsp-isv-mz.122-8.T5.bin"

cisco RSP2 (R4700) processor with 131072K/2072K bytes of memory.

R4700 CPU at 100Mhz, Implementation 33, Rev 1.0

Last reset from power-on

--------------------------------boot info------------------------------------------

SLOT 2 RSP2 is system master

SLOT 3 RSP2 is system slave

RSP2 processor with 131072 Kbytes of main memory

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCreading the file into memory...

Self decompressing the image : #################################################

################################################################################

#############################################################

###################

####################################### [OK]

00:00:13: %SYS-3-LOGGER_FLUSHING: System pausing to ensure console debugging output.

<=================error message

%DBUS-3-BADCTRLRTYPE: Invalid controller type 34 in slot 1

-Traceback= 60210258 602104A0 60210A3C 602114C8 60214658 601D329C 601D3350 6014B6E4 6014B950 601B96C4 601B96B0

00:00:13: %SYS-3-LOGGER_FLUSHING: System pausing to ensure console debugging output.

%DBUS-3-BADEEPROM: Invalid EEPROM data found for card in slot 1, card disabled

00:00:40: %SYS-3-LOGGER_FLUSHING: System pausing to ensure console debugging output.

Frederic Vanderbecq · ‎10-23-2002

When the router has completely booted, is the card in slot1 recognized and working properly ? If the card is indeed working properly when the router is up, these messages are then problably linked to the boot image which does not recognize the card. You may simply to upgrade it to a release recognizing it.

If the card is not recognised or recognised but not working properly when the router is up, we might be looking to a bad card.

guicong.yang · ‎10-24-2002

yes. the card in slot 1 can work after IOS has loaded.

but 7507 boot image has upgraded .

when there is this error message ,

the

boot image : 12.0(4)