02-12-2005 07:44 PM - edited 03-02-2019 09:38 PM
Hi....
The following shown is my a Cat5000 Switch output.
---------------------------------------------------
#radius
set radius server 211.252.87.126 auth-port 1812
set radius server 10.98.14.31 auth-port 1812 primary
set radius timeout 10 <--------- 1
set radius retransmit 3 <-------- 2
set radius key data
!
#authentication
set authentication login radius enable console primary
set authentication login radius enable telnet primary
set authentication enable radius enable console primary
set authentication enable radius enable telnet primary
-----------------------------------------------------
My question.
1. If no timeout value is specified, how is the default value ?
2. If no retransmit value is specified, how is the default value ?
I wait for your answer.
Thank you...
This is South Korea.
Solved! Go to Solution.
02-13-2005 03:15 PM
set radius timeout default timeout is 5 seconds.
set radius retransmit default is 2 times (initial attempt plus 2 retransmit attempts for a total of 3 attempts)
This is based on CatOS 6.2, check the command reference:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_6_2/cmd_ref/setsn_su.htm#13791
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_6_2/cmd_ref/setsn_su.htm#12813
HTH
Mustafa
02-13-2005 03:15 PM
set radius timeout default timeout is 5 seconds.
set radius retransmit default is 2 times (initial attempt plus 2 retransmit attempts for a total of 3 attempts)
This is based on CatOS 6.2, check the command reference:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_6_2/cmd_ref/setsn_su.htm#13791
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_6_2/cmd_ref/setsn_su.htm#12813
HTH
Mustafa
02-14-2005 02:50 AM
Hi.....
Thank you for your answer.....
Good luck to u and have a nice day.......
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide