Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
754
Views
0
Helpful
3
Replies

Configuring point to point leased line

rmrahman0302
Level 1
Level 1

‎02-03-2005 10:11 AM - edited ‎03-02-2019 09:28 PM

I have two locations are connected via full T1 leased line. Hardware is Cisco 1721 router. I did configure encapsulation type to Cisco and LMI type to Cisco. Also I did configure service-module T1 source line on one location. Service provider is working on the T1 line. I want to verify that my configuration is ok.

Appreciate your help.

Labels:
0 Helpful
3 Replies 3

vmiller
Level 7
Level 7

‎02-03-2005 10:14 AM

Is your T-1 Frame relay?

0 Helpful

rmrahman0302
Level 1
Level 1
In response to vmiller

‎02-03-2005 10:15 AM

Yes

0 Helpful

vmiller
Level 7
Level 7
In response to rmrahman0302

‎02-03-2005 04:20 PM

configure the device at the far end the same. your carrier should provide you the necessary frame relay information (dlci). double check with them on the LMI type

0 Helpful
Customers Also Viewed These Support Documents