03-14-2006 01:21 PM - edited 03-03-2019 02:17 AM
simple question: I can't remember how to resolve the following issue on my console connection via a term server -
i connect in and then observe the following 'echo' when entering a command:
sshh rruunn
each character gets 'echoed' i seem to remember this being an exec config on either the cisco router or the terminal server.........any suggestions?
03-14-2006 01:46 PM
Hello
I think this is actually specific for the application you are using,
if it was a WINDOWS HYPERTERMINAL, you would go to:
FILE: PROPERTIES: ASCII SETUP and then check (or un-check) the box :
echo typed characters locally
Do a basic search for ECHO options on your terminal application.
Vlad
03-14-2006 07:44 PM
I believe that Vlad is on the right track with his suggestion.
You should also be sure that the terminal server has configured no exec on the lines that will be used for reverse telnet.
HTH
Rick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide