Migration from Cisco CSS to Netscalers

[karamak2]

Hello,

We are migrating from Cisco CSS to netscalers. I had a question in this. My old CSS configs had bridge vlan and circuits. How do I interpret this in Netscalers?

Please feel free to move to appropriate forum. 

[Marvin Rhoads]

Circuits and bridge VLAN are sort of like trunk and associated interfaces in the Netscaler.

Rather than try to map things 1-1, try to parse the CSS configuration lay out the overall logical flow  from clients to servers and then configure that in the Netscaler.

[karamak2]

Thanks Marvin. I am just not quite sure of configuring the circuits. I tried to do as the way you had proposed, but I am not sure if I have all that is required.

How do I create circuits on netsclaers?

[Marvin Rhoads]

karamak2  

It's been a while (4+ years)  since I've touched a CSS. I don't have access to any in my current position. You might get better support asking in the Citrix Netscaler forum.

https://discussions.citrix.com/forum/1356-netscaler-application-delivery/