cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1486
Views
0
Helpful
2
Replies

Router hangs at initial configuration dialog?

AdamZampa
Level 1
Level 1

Hello,

 

my 2620 hangs at the initial setup:

 

-------------------------

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-I-M), Version 12.0(7)XK1, EARLY DEPLOYMENT RELEAS

E SOFTWARE (fc1)

TAC:Home:SW:IOS:Specials for info

Copyright (c) 1986-2000 by cisco Systems, Inc.

Compiled Wed 15-Mar-00 04:28 by phanguye

Image text-base: 0x80008088, data-base: 0x8080DBA0

 

cisco 2620 (MPC860) processor (revision 0x600) with 45056K/4096K bytes of memory

.

Processor board ID JAD05320R17 (3691429275)

M860 processor: part number 0, mask 49

Bridging software.

X.25 software, Version 3.0.0.

1 FastEthernet/IEEE 802.3 interface(s)

32K bytes of non-volatile configuration memory.

8192K bytes of processor board System flash (Read/Write)

 

 

--- System Configuration Dialog ---

 

Would you like to enter the initial configuration dialog? [yes/no]:yes

 

----------------------

 

I can't get into rom Mode either.

 

Any ideas?

 

2 Replies 2

Mark Elsen
Hall of Fame
Hall of Fame

 

 - Probably not related but check full operation of the serial-operator-interface-app you are using on another device , chances that relates are small , but it's worth a check. Otherwise factory reset the 2600 and try again.

 M.



-- Let everything happen to you  
       Beauty and terror
      Just keep going    
       No feeling is final
Reiner Maria Rilke (1899)

Hello,

 

your device (and IOS version) are from around the turn of the century (when Bill Clinton was still the president of the US). Chances are your flash is broken, that is usually the first thing that goes with these ancient devices.

 

I guess you have tried to get into ROMMON by powering off/on the router, then hitting the BREAK key on your keyboad...?

 

If that does not work, I am afraid your device is dead.