Hello,
I am struggling to understand a way around a problem that has arisen since I upgraded my 515e failover pair to v7.0(2).
We used to NAT 2 different IP addresses through the PIX to the same internal IP address using the following commands:
static (inside,outside) 195.195.195.11 192.168.0.13 netmask 255.255.255.255 0 0
static (inside,outside) 195.195.195.10 192.168.0.13 netmask 255.255.255.255 0 0
However, since the upgrade, the new version of the PIX software doesn't "allow" this kind of configuration, which, from the reading that I have done since, I can understand.
My question is, is there a way around this problem? Because although we can rationalise the 2 external IPs pointing to one internal IP by merging the 2 external IPs into one, we are experiencing the same problem with VPN traffic that used to work with the following command:
static (inside,outside) 192.168.0.13 192.168.0.13 netmask 255.255.255.255 0 0
The new version does not allow these two commands to exist on the PIX without giving the referring error:
static (inside,outside) 195.195.195.10 192.168.0.13 netmask 255.255.255.255 0 0
static (inside,outside) 192.168.0.13 192.168.0.13 netmask 255.255.255.255 0 0
Your assistance is appreciated.
- Edward