cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
718
Views
0
Helpful
1
Replies
rajasbha
Beginner

CAS error

Hi,

I am not able to ping the CAS server from the switch , but am able to ping CAM

From desktop , I can also ping the CAS server  and my AD

Any help is highly appriciated -thanks in advance

In mesages  I see the following error

NAS2 racoon: INFO: 192.168.17.231[500] used as isakmp port (fd=10)

Jun 13 NAS2 racoon: INFO: 192.168.17.231[500] used for NAT-T

Jun 13 NAS2 racoon: INFO: 192.168.0.231[500] used as isakmp port (fd=11)

Jun 13 NAS2 racoon: INFO: 192.168.0.231[500] used for NAT-T

Jun 13 -NAS2 racoon: ERROR: failed to bind to address 192.168.15.230[500] (Address already in use).

Jun 13 NAS2 racoon: ERROR: failed to bind to address 192.168.1.230[500] (Address already in use).

Jun 13 -NAS2 racoon: ERROR: failed to bind to address 192.168.1.230[500] (Address already in use).

Jun 13 -NAS2 racoon: ERROR: failed to bind to address 192.168.1.230[500] (Address already in use).

Jun 13 NAS2 racoon: ERROR: failed to bind to address 192.168.1.230[500] (Address already in use).

1 REPLY 1
Shrikant Sundaresh
Cisco Employee

Hi Rajashree,

In an L2 setup, ideally, you wouldn't be able to ping the CAS untrusted from the switch, since there is no SVI for the untrusted VLAN.

However, to troubleshoot your issue, a detailed topology diagram would be required.

If you can provide a topology with ip addresses of CAS/CAM/Switch and desktop marked, along with the SVIs and routes on the switch, we might be able to troubleshoot the issue.

-Shrikant

Content for Community-Ad

This widget could not be displayed.