06-12-2002 10:22 AM - edited 03-08-2019 10:57 PM
Hi all
I have problem with reports in CSPM 3.0 F
I get following reports (Summary Report=>Event Summary,Detailed Report=>Detailed Report) and some basic reports.. (Administrator activity and etc)
but i cant get Summary Report =>Network Traffic Summary,User Activitiy Summary,Most Active Users etc..,Detailed Report=>Detailed Network Event
Detailed User Activity etc..
I checked Tools=>Configure Notifications and seems all selected as Log..
And i had no problem regarding these reports before .First i encountered this problem at my customer after upgrading PIX 6.2(1) PDM 2.0(1)
and i suspected version upgrade and so i downgrared and tried again but problem existed.
I tried these at my company and i get same situation.
And idea ?
Thanks in advance
06-18-2002 11:49 AM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
06-18-2002 04:15 PM
Hi,
I have had this issue with CSPM version 2.3 and it turned out to be the syslog level that was set within the PIX. According to the following doc it should be set to Informational or Debug to get the level of reporting you require.
http://www.cisco.com/univercd/cc/td/doc/product/ismg/policy/ver30/topol/ch04.htm#xtocid2102517')">http://www.cisco.com/univercd/cc/td/doc/product/ismg/policy/ver30/topol/ch04.htm#xtocid2102517
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide