Hi all,
I have just installed a 4FE interface card for dmz on our pix 515ur, my problem and questions is, how do I see the new interface, I can´t see them on the configuration? do I need licences? thsi is my pix version:
Cisco PIX Firewall Version 6.2(1)
Cisco PIX Device Manager Version 2.0(2)
Compiled on Wed 17-Apr-02 21:18 by morlee
Site up 31 mins 30 secs
Hardware: PIX-515, 64 MB RAM, CPU Pentium 200 MHz
Flash i28F640J5 @ 0x300, 16MB
BIOS Flash AT29C257 @ 0xfffd8000, 32KB
0: ethernet0: address is 0004.9ad0.eb96, irq 11
1: ethernet1: address is 0004.9ad0.eb97, irq 10
Licensed Features:
Failover: Enabled
VPN-DES: Enabled
VPN-3DES: Disabled
Maximum Interfaces: 6
Cut-through Proxy: Enabled
Guards: Enabled
URL-filtering: Enabled
Inside Hosts: Unlimited
Throughput: Unlimited
IKE peers: Unlimited
Thanks, in advanced
David
