Does PIX 501 (ios 6.2) support NTP and turbo ACLs?

[darekkuzma]

Does PIX 501 (ios 6.2) support NTP and turbo ACLs? When I do question mark under config t ntp is not displayed. Same applies to turbo ACL option.

I haven't found any info that 6.2 is on 501 is a limited version and doesn't support them.

Any advices?

[pgolding]

turbo acl is not supported on pix with less than 16M ram, which includes the 501. this is mentioned in the command reference under access lists. ntp should work.

[ods]

If you try to compile an access-list with "access-list compiled" on a PIX-501, you will receive a message that the 501 do not support Turbo ACLs.

Since all PIX-501s actually have 16MB og SDRAM, I am not sure why this is the case. This is possibly some of the functionality they had to eliminate to get by with 8 MB of Flash (incl. PDM).

pixfirewall access-list ?

The PIX-501 actually lists "compiled" as a valid keyword on the 501, but that must be a bug... ;-)

The NTP command is actually a bit misplaced in the command listing from:

pixfirewall ?

It is listed after object-group, but it is there and it works. I am currently running it on my PIX-501 using Finesse 6.2(2). It is even supported in PDM 2.02...