firewall problem

[Mohammed Gomaa]

dears,

can i Add secondary ip address to 506 firewall interface to support two different network

[Patrick Iseli]

No this is not possible on the PIX Firewall.

You need an internal router to that or you can configure VLANs to a layer 3 capable Switch.

sincerely

Patrick

[m.sir]

PIX 506 doesnt support secondary Ip, but you can use trunk with dot1q encapsulation

try following document Using VLANs with the Firewall:

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a0080172786.html#wp1113411

M.

Hope that helps, rate if it does