FTD sensors don´t show command output from CLI

[Eduardo Marin]

Hi all,

I have a strange behaviour with two FTD sensors (FPWR 2130). After upgrade to  6.2.3.6, when I try to do something in the sensors themselves through CLI (for instance, show route), sometimes the sensors give the output, sometimes I obtain nothing or it takes ages to ahor the information.

Prior the upgrade I saw this behaviour but it wasn´t common, now I experience it most of the time.

The platform is not deployed in production yet, and the cpu-usage and traffic are very low.

Have any of you experienced something like this?

TIA

[Abheesh Kumar]

Hi,

Are you executing all these commands from " system support diagnostic-cli" 

HTH

Abheesh