cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
422
Views
0
Helpful
1
Replies

How to exclude single IP not working

mjhagen
Level 1
Level 1

I am using CSPM 2.3.3i to monitor my IDSM modules version 3.0(3)S10. I setup an advanced filter to block DNS signature (6053) from a single IP address to any. I save the policy and reload the database and the filter does not block the signature.

1 Reply 1

ciscomoderator
Community Manager
Community Manager

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.