04-19-2003 10:58 PM - edited 03-09-2019 02:57 AM
hi engineers ,
i setup IDS along with CSPM ,managed them and configure proper host IDs and ORG IDs and so on .
i think everything is ok ,i can ping the sensor .
but i cann't touch what is sensed in my database ,it is always empty with only three lines ,the last one is "route up "
any comment ,mostly appreciated !
thanks
04-21-2003 01:25 AM
If you have connectivity (i.e. seeing the route up), it may just be that you haven't told the sensor what interface to sniff on.
In CSPM, do a File>Save&Update. Then, go to the Command Tab, and do an "approve now" to push your config out to the sensor.
See the following doc for more details/troubleshooting:
Configuring a Cisco Secure IDS Sensor in CSPM
http://www.cisco.com/warp/public/707/ids2cspm_6117.html
HTH
Jeff
04-21-2003 05:43 AM
thank u very much ,
at least you said some word .
ciao
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide