IP LOGGING for IDSM Blades.

s.ferreira · ‎08-15-2002

Is there a way to log traffic for an IP address on the IDSM Blade just like it is done for the stand alone sensors. I do not see a tab for "Ip logging Addresses" on my unix director.

marcabal · ‎08-15-2002

The IDS Module does not support "IP Logging". Please refer to the following link for a list of some differences betweem the Module and Appliance sensors:

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/idsm/idsm_2/13726_04.htm#xtocid12

s.ferreira · ‎08-15-2002

Are there plans for this future to be implemented. It is hard to take legal actions sometimes without raw data.

s.ferreira · ‎08-15-2002

Are there plans for this future to be implemented. It is hard to take legal actions sometimes without raw data.

marcabal · ‎08-16-2002

We have had this feature requested from several users of IDSM.

BY general rule we do not, however, discuss what is going into future product version on the NetPro Forum.

Please contact you Cisco representative for questions about future products.