Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
645
Views
0
Helpful
4
Replies

Password Command

mmellet
Level 3
Level 3

‎04-04-2001 01:58 PM - edited ‎03-08-2019 08:08 PM

I have a fairly simple question that hopefully someone can help me out with. I have the Catalyst 6000 IDS module and was wondering if anyone knows the command to change it?

TIA

Labels:
0 Helpful
4 Replies 4

scothrel
Level 3
Level 3

‎04-04-2001 02:29 PM

What do you mean by "change it" ?

0 Helpful

mmellet
Level 3
Level 3
In response to scothrel

‎04-05-2001 07:56 AM

I'm looking for the command line I need to type in order to change the password.

TIA

0 Helpful

scothrel
Level 3
Level 3
In response to mmellet

‎04-05-2001 08:58 AM

The password is set as the first option under the "setup" command. you can change the password and then just "return" through the rest of the config if it is correct.

Scott Cothrell

0 Helpful

marcabal
Cisco Employee
Cisco Employee
In response to scothrel

‎04-05-2001 09:59 AM

If your sensor module has al;ready been configured and is currently monitoring then you should not use setup to change the password. The setup command will also re-initialize all of your configurations and place them back to factory defaults. Instead use the password command within the "configure terminal" mode.

0 Helpful
Customers Also Viewed These Support Documents