privilege level to allow interface FastEthernet but not GigabitEthernet

[franklinwong]

Any way to allow access to FastEthernet interfaces but not GigabitEthernet interfaces using the privilege level command?

[John Blakley]

You would have to assign all of the interfaces manually for the privilege level that you want to allow access to. You could also assign a view if your device supports it.

HTH,

John

[franklinwong]

Hi John,

Thanks for your reply.

I applied the command "privilege configure level 10 interface FastEthernet0/1" but the user can also get into other interfaces. I discovered that whenever there is "privilege configure level 10 interface" in the command, no matter what follows, the user can access all interfaces, including FE, GE, Vlan, etc.

Any idea?