Router SDM basic Firewall configuration

[rleung2001]

I am taking cisco router security class, I tried to setup the Basic Firewall from a router 2600xm SDM 2.1, I clicked the basic firewall button and selected the trusted and untrused inteface, then there a check mark on "Allow EIGRP updates to come throught the firewall". Why RIP and OSPF unavailable?

[haris.cisco]

hi,

is RIP & OSPF is configured on the router ?

regrds

haris

[rleung2001]

no. According to the lab assignment, I didn't select any routing protocol.

1.Select Basic Firewall

2.click launch the selected task

3.The firewall wizard screen appears

4.For the outside interface, select FA0/1 interface

5.For the inside interface, select FA0/0 intefface

6.Make sure the Access rule log option is checked

7.verify the firewall configuration is correct

8.Make sure the save to the router's startup config is not checked

9. once the configuration summary is correct, click finish to deliver the configuration to the router). Make sure to check Allow EIGRP updates to come through the firewall

10. Why RIP and OSPF unavailable?

(my teacher can't answer this question either)