Other Security Subjects

For interfaces configured as same security level, and global command "same-security-traffic permit inter-interface ".The traffic will flow between interfaces without require any NAT command. And by default traffic flow freely without access-list.If I...

We have enebaled telnet access on a security context and recive a telnet connection but no prompt. Is there anything special you need to do on a context to get telent working on a context. The device I am using to telnet from is a device within the s...

Has anyone tackled error messages when recieving events from Snort 2.3.3? MARS says Unknown Device Event Type for everything so far. Drill down on the raw shows semi important things like an nmap probe or a port scan but MARS template doesnt seem t...

I was wondering what the best practice is for accessing remote routers or switches over the Internet. I don't think locking telnet access to a specific IP via ACL is the best practice and was wondering if SSH is any better. Typically I would have a ...

Hi all, I have a slight problem, any assistance is appreciated. I have a dsl connection coming into a cisco adsl router which does NAT (10.10.10.0), from the router the connection then goes into the a PIX 506e which also does NAT(192.168.1.0).I'v...

Hi,I have installed SW 3.1.1 on my FWSM. The documentation says that ADSM 5.0F is included in 3.1.1. (http://www.cisco.com/en/US/partner/products/hw/modules/ps2706/products_data_sheet0900aecd803ded77.html).Because I couldn't find/activate ADSM 5.0F I...

Hi there all,I am about to roll out some new 7206 DMVPN headend routers and wanted to know if anyone has any experience with stable IOS versions for this.We have used 12.3(6a) until now, but I would like to move to the 12.4-train if possible. Haseeb ...

PIX 520 Firewall with 16M Flash and 128M RAM has running version 6.3(5).But I cannot install pdm 3.0(4) or even 3.0(3) on it. PIX says - Not pdm image. The md5 summ was checked.What is the problem?

Hello,With a ASA + AIP-SSM can i limit the number of connection to one URL?, i can not limit by ip because in the same ip i have various IP.Regards.

On day 3 of a CSA 5 pilot my client has reported that the external SQL database they are using is now experiencing slowness. They are seeing that the new CSAMC50 has multiple processes open that are not closing as they think they should. My question,...

Hi! I have the following project to realize. 5 locations should be connected over the internet. A first draft of a network-diagram you can find on http://www.besse.at/uploader/files/network.jpg (soory, in german). Three branches (at the right) all ha...

Hi everyone, I have this setup Inside OutsidePhone(pots)----h323gw----FWSM-----|--IPphone | callmanager(outside)The ip addresses are as follows on h323gateway to...

I have a 3005 and it has a vpn to a 3002 HW Client. The tunnel goes down and times out all the time. IS there a way to keep it up permanently?

We have some tunnels that will not pass traffic. I can reach the remote router through the tunnel but unable to pass traffic.